Cable Driver LS1 motor LS2 Wiring , LS3 wiring , Vortec

$450.00

This is the complete mechanical cable control solution for the 4L60E, powered by the LT1, LS1 and Vortec. The signal rides off of the 40 tooth reluctor ring, located on the output shaft.

The IC logic accepts the pulse then spins the motor and cable at the correct rate. The MCC (mechanical cable controller) is fully programmable, to any, drive and driven gear combination you have.

This is the best way to run an automatic, for one sole reason. The other option you have is, convert the rear case to accept the VSS reluctor, plus the drive and driven gear. Remember you must have the original 4L60E for this unit. It works off of the factory reluctor ring.


Add to Cart:

  • Model: LT1 LS1 Vortec Speed Sensor 4L60
  • Shipping Weight: 12lbs
  • 99 Units in Stock
  • Manufactured by: Speed Scene Wiring. LLC


This product was added to our catalog on Saturday 23 October, 2010.

Your IP Address is: 18.97.14.85
Copyright © 2024 Speed Scene Wiring.